Re: How to config a IPv4-over-IPv6 tunnel?

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On 15/06/2010 18:18:19, Bear wrote:

> I am a administrator of a school network. My school has already
> deployed a pure-IPv6 network with NAT-PT. But there are massive
> applications cannot support IPv6, so these applications cannot work
> at all. Now I *DO NOT* wanna build a dual-stack network, because if I
> build a dual-stack network, IPv6 will have no users, all users will
> use IPv4 to communicate with the websites which in IPv4 network. So I
> wanna build a tunnel, the start-point is client, the end-point is a
> special dual-stack machine. Also, a sock5 proxy is all right. Could
> you tell me how to do this? thx!

gif(4)

	Cheers,

	Matthew

- -- 
Dr Matthew J Seaman MA, D.Phil.                   7 Priory Courtyard
                                                  Flat 3
PGP: http://www.infracaninophile.co.uk/pgpkey     Ramsgate
JID: [email protected]               Kent, CT11 9PW
-----BEGIN PGP SIGNATURE-----
Version: GnuPG/MacGPG2 v2.0.14 (Darwin)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/

iEYEARECAAYFAkwXvXcACgkQ8Mjk52CukIyBFgCdFfwzBD9XhiomAdynDobhbO9O
a/IAn3OSeNLqFOD3KzHNG/XwDLnUMa72
=B2iT
-----END PGP SIGNATURE-----
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-isp
To unsubscribe, send any mail to "[email protected]"