Re: How to config a IPv4-over-IPv6 tunnel?

I'm curios, what are you using for your NAT-PT?

On Tue, Jun 15, 2010 at 11:18 AM, Bear <[email protected]> wrote:

> hi,
> I am a administrator of a school network. My school has already deployed a
> pure-IPv6 network with NAT-PT. But there are massive applications cannot
> support IPv6, so these applications cannot work at all. Now I *DO NOT* wanna
> build a dual-stack network, because if I build a dual-stack network, IPv6
> will have no users, all users will use IPv4 to communicate with the websites
> which in IPv4 network. So I wanna build a tunnel, the start-point is client,
> the end-point is a special dual-stack machine. Also, a sock5 proxy is all
> right. Could you tell me how to do this? thx!
>
> --------------
> Bear
> 2010-06-16
>
> _______________________________________________
> [email protected] mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-isp
> To unsubscribe, send any mail to "[email protected]"
>
_______________________________________________
[email protected] mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-isp
To unsubscribe, send any mail to "[email protected]"