Re: Wireguard interface on RPI evbarm

On Fri, May 01, 2026 at 04:44:38PM +0000, John Klos wrote:
> Many providers that give native IPv6 and CG-NAT IPv4 will allow IPv6
> incoming.

Mine is CG-NAT + dynamic IP. I haven't tried, but there are settings to
forward port, so I guess incoming is allowed.

I can possibly run Wireguard endpoint on Pi. But would I need DDNS to work
around the dynamic IP?

My current attempt involved making a VPS with static IP The end point.
With some UDP hole punching, I was hoping to reduce the latency between
the peers, with some way to reduce P2P latency such as UDP Hole punching.
(VPS to either peer has high latency, peer to peer has low latency.)

-- 
Mayuresh