Re: boot26 on R260

Ben Harris <[email protected]> Wed, 9 Feb 2005 10:51:51 +0000 (GMT)

Newsgroups	gmane.os.netbsd.ports.arm26
Message-ID	<[email protected]>

On Tue, 8 Feb 2005, Michael wrote:

> I switched to supervisor too, but I didn't change to 256 colours ( stuck to 
> 16 to save memory ) - I'll try that too.

256 colours are required because last time I looked at it the NetBSD 
raster console code couldn't support little-endian framebuffers at <8bpp. 
It's possible that this is fixed now.

>> Stray IRQ, status=0xf1f1, spl=0, mask=0x0
>> 
>> The 1.62 installation kernel does not show these messages, but seems not to
>> recognise the Ether1 card. Utility menu/Configure network does not let me
>> configure a network card, it does not find one.
> Hmm, last time I tried (around 1.5 or so) it didn't find my ANT Ether3 - - 
> maybe it will work now.

If it doesn't, please submit a PR.

-- 
Ben Harris                                                   <[email protected]>
Portmaster, NetBSD/acorn26           <URL:http://www.NetBSD.org/Ports/acorn26/>