Re: boot26 on R260

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hello,

>> I switched to supervisor too, but I didn't change to 256 colours ( 
>> stuck to 16 to save memory ) - I'll try that too.
>
> 256 colours are required because last time I looked at it the NetBSD 
> raster console code couldn't support little-endian framebuffers at 
> <8bpp. It's possible that this is fixed now.
Maybe it is, if not I could probably do it - spent the last few months 
hacking console/framebuffer drivers on other platforms. But this 
requires getting it to boot.

>>> Stray IRQ, status=0xf1f1, spl=0, mask=0x0
>>> The 1.62 installation kernel does not show these messages, but seems 
>>> not to
>>> recognise the Ether1 card. Utility menu/Configure network does not 
>>> let me
>>> configure a network card, it does not find one.
>> Hmm, last time I tried (around 1.5 or so) it didn't find my ANT 
>> Ether3 - - maybe it will work now.
>
> If it doesn't, please submit a PR.
Last time I tried ( ages ago ) /some/ Ether3 boards were supported but 
not mine. Do these boards just share the name for some reason or is the 
hardware sufficiently similar to be supported by a single driver?

have fun
Michael
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (Darwin)

iQEVAwUBQgoNDcpnzkX8Yg2nAQLJCQf/SU9zwprbYccvKcO6mQPBoKaKB2MSBTdh
to/FXVwMo7ILVuAp65QMiOZpgoG75g91kAc62pdmjVcHEkTNTNor1aX2KkhGmNml
4ncpelQ15LL05M0pUeZZFjj6rxMo8DgfdYY7p+VqonY2uGuIfMc8CR/vyN1h/Ug+
+2MQi1g+3m3g2pv7j/BrasyGNHZ+HbwLrI27H+qdd5OGSmfcGQaB2o4sqWam0W04
4cQ/+7uE2qNGpQVaABsOu1vRVkZz5KobUphflmgrBXpUPKFHxGG1XZmeX2hllEoK
K4VrCi+KBAwdhPBGejyOL0ILqo+Onv5fLX42DqNnNvXkRKzVl9B3Aw==
=lsvc
-----END PGP SIGNATURE-----