Re: Autoconf-ing mklifboot
Jochen Kunz <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.hp700 |
|---|---|
| Message-ID | <[email protected]> |
On Sat, 12 Jun 2004 11:35:54 +0900 (JST) [email protected] (ITOH Yasufumi) wrote: > Building disklabel(8) with -DSAVEBOOTAREA or -DNUMBOOT > might help to preserve the boot block. Found already that -DNUMBOOT=1 helps a lot. Even -B works. The firmware now recognizes the disk as bootable ("search ipl"), but gives this error when I attempt to boot the disk: IPL error: bad IPL checksum. I'll investigate this later. > PA-RISC 2.0 Firmware Architecture Reference Ahh, now I know why I didn't find anything. I looked at the PA-RISC 1.1 doc. -- tschüß, Jochen Homepage: http://www.unixag-kl.fh-kl.de/~jkunz/