Re: LSI MegaRAID installation
Mouse <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.x86-64,gmane.os.netbsd.ports.i386 |
|---|---|
| Message-ID | <[email protected]> |
>> I can't see anything in dmesg.boot: it's conceivable that if RAID >> mode is not configured in the BIOS then the chip won't show up I >> suppose. > You will still see the PCI device, e.g.: > vendor 1000 product 0016 (RAID mass storage, revision 0x01) at pci11 dev 0 function 0 not configured Sometimes. I have seen cases where, as Steve says, a device that's disabled at the BIOS config level is not visible on the system buses at all. Is there some reason it's impossible this could be such a case? /~\ The ASCII Mouse \ / Ribbon Campaign X Against HTML [email protected] / \ Email! 7D C8 61 52 5D E7 2D 39 4E F1 31 3E E8 B3 27 4B