Re: space for basic installation - hang
Riccardo Mottola <[email protected]>
| Newsgroups | gmane.os.netbsd.ports.sparc |
|---|---|
| Message-ID | <[email protected]> |
Hi, I took the bite and reformatted the root partition with the default parameters... since I have a separate home setup, data loss will be minimal. Now I don't get out of space messages, but installation just hangs: E.g.: Status: Running Command: progress -zf /targetroot/home/install/modules.tgz tar --chroot -xpf - qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq 1% | | 127 KiB 0.03 KiB/s - stalled - I can leave this with for hours. It is not frozen, I can hit enter and get a newline, ctrl-c, the command ends, menus get back and I can start again. I repeat, modules.tgz will stall in the exact same place! If I skip and pass on to base.tgz, which is surely "bigger". It downloads all and unpacks! Same for all other packages... You selected 17 distribution sets. 0 sets couldn't be found and 1 were skipped after an error occurred. Of the 16 that were attempted, 16 unpacked without errors and 0 with errors. strange, isn't it? I'm on serial console, so I suppose if there were some error message I would see it? After completing the install of everything, except modules... I tried to reinstall that single set. 44% |*************** | 3135 KiB 12.79 KiB/s - stalled - I retry: 1% | | 127 KiB 7.93 KiB/s - stalled - 127KB.. as all the first attempts what is so difficult in it??? Riccardo