| Newsgroups |
gmane.os.netbsd.ports.sun3 |
| Message-ID |
<[email protected]> |
> use the arp command to dump ARP tables and look for suspicions or
> correctness
> there should be an entry for every IP destination you have attempted to
> contact
> via the Ethernet interface
That there is, I can use arp -a to see the MAC addresses of each machine I
ping while the interface is working. When the network stops working,
however, arp -a doesn't yield a result. I see traffic transmitted on the
hub, but none of it seems to be able to get anywhere.
> use the ifconfig command to verify status of your Ethernet interface
shows status: active
> use the netstat command (with -i ???) to look at interface statistics
I did a ping for 14 times, the first one went through, then netstat -i
showed 18 ierrs. So, the packets are transmitting correctly but not
receiving?
> use the lamps (LEDs) on all the hub gear to see whom is/is not
> transmitting
As far as the lamps are concerned, all seems to be ok. Both lights flicker
on a ping, even when the interface stops functioning.
> then check receive statistics at various machines to see if counts are
> increasing;
Until the interface stops working, yes. After that, the ierr count on the
Sun3's interface just increases.
> make sure you have at least one known good PC/workstation/gizmo on your
> little LAN to generate traffic and examine receive stats on
Check.
> check your routing tables! Perhaps the outbound traffic no longer is being
> routed to the correct interface
route get default hangs after the interface dies, but behaves correctly
before that.
>
>
> Have fun,
> Rick
>
>
>
Thanks!
Zach