Re: Wireguard doesn't seem to work on macppc 7.8

Hello,
On Thu, May 14, 2026 at 08:30:02AM +0200, Gabriele Vento wrote:
> 
> 
> On May 14, 2026 12:48:03 AM GMT+02:00, Vitaliy Makkoveev <[email protected]> wrote:
> >On Wed, May 13, 2026 at 08:54:24AM -0600, Theo de Raadt wrote:
> >> Is this a byte order problem?
> >> 
> >
> >I just check wg(4) on my Powerbook G4. Everything works fine. It runs
> >"OpenBSD 7.9 (GENERIC) #54: Fri May  8" but I'm pretty sure 7.8 should
> >also work fine.
> >
> >Gabriele, what do yo mean saying "just doesn't work"? Does it failed to
> >connect to the peer or does it successfully connect, but traffic does
> >not go within tunnel?
> Traffic does not go within the tunnel.
> 

    can you share output of `ifconfig wg` for both tunnel ends?
    optionally content of /etc/hostname.wgX on both endpoints.
    Make sure to redact/remove any keys for tunnel.  I suspect
    there might be issue with wgaip settings which Stuart mentioned.

    also if you can check output of
        route get $IP_address_reached_over_tunnel
    command should help us to tell the routing works as expected,
    you can use remote tunnel peer's address.

    also any chance pf(4) drops traffic for wg-tunnel?

thanks and
regards
sashan