RE: hang on reboot

http://www.openbsd.org/faq/faq14.html#D0P3

'disk setup' section

-----Original Message-----
From: Mike DeMan [mailto:[email protected]]
Sent: Thursday, June 06, 2002 9:14 PM
To: [email protected]
Subject: Re: hang on reboot


Hi,

The FAQ was a good idea but it didn't seem to work.  Maybe my speed=20
reading isn't what it used to be, but overall the FAQ seems to support=20
my original assumption that the reboot command under OpenBSD functions=20
basically the same as it does under other BSD, linux and commercial UNIX =

variants.

Is there something special about OpenBSD where it refuses to mount the=20
drive or something after a software reboot?

If I just pull the power on the unit it comes right back up just fine=20
and dandy.

If I use /sbin/reboot it hangs at the spot I mentioned.  I'm somewhat=20
suspicious it could be a Soekris 4501 firmware glitch or something too.

- Mike

On Thursday, June 6, 2002, at 06:32 PM, Justin Honold wrote:

> embsd is a stripped version of openbsd
>
> openbsd has a faq
>
> -----Original Message-----
> From: Mike DeMan [mailto:[email protected]]
> Sent: Thursday, June 06, 2002 8:12 PM
> To: [email protected]
> Subject: hang on reboot
>
>
> Hi,
>
> I recently got emBSD running on a Soekris 4501.  Everything seems to
> work great except if I reboot the unit (/sbin/reboot) it never comes
> back up.  I just get
>
> Using Drive: 0 Partition: 3
>
> and it hangs.
>
> - Mike
>
>
>