Re: HP9000 K-Series support

Fyi, i've setup OpenBSD-current on a 715/64 (after trying unsuccessfully
to get build cross tools on i386, probably my fault ..) and have the K
remote booted from that machine.

After quite some time hacking the source, reading the fine PDC manual
and studying the debian-parisc source, today i got the K220 booted to
the point where it asks for installing or go to a shell.

Now i need a driver for the built in Fast-Wide-Diff SCSI bus .. ;-)

hellmuth
-- 
Hellmuth Michaelis      Hamburg, Europe      hm\at\kts\dot\org      www.kts.org
a duck is like a bicycle because they both have two wheels except the duck (tl)


Main Menu: Enter command or menu > bo lan 172.42.42.42 install
Interact with IPL (Y or N)?> n

Booting... 
Network Station Address 080009-d436b8

Boot IO Dependent Code (IODC) revision 2


HARD Booted.

>> OpenBSD/hppa BOOT 0.8
|/-\|/-\|booting lf0a:/bsd: /-\|/-\|/-\|/-\|/-\|/-1291256\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/!
 
 -\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-+2650112\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\!
 
 |/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-
\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|!
 
 /-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\+356352=0x65e158
con: class 7 flags 0 bc -1/-1/-1/-1/10/4 mod 0 layers 0/0/0/0/0/0 hpa f1900000
kbd: class 7 flags 0 bc -1/-1/-1/-1/10/4 mod 0 layers 0/0/0/0/0/0 hpa f1900000
PDC_CACHE_SETCS: 0, 0, 0, 0 (-2)
SPID bits: 0x0, error = -2
pdc_coproc: 0xc0, 0xc0
btlb info: minsz=128, maxsz=16384
btlb fixed: i=0, d=0, c=16
btlb varbl: i=0, d=0, c=0
HP 9000/859/K220 (ThunderHawk DC3- 120 1M) PA-RISC 1.1ahm: cpuid done
hm: ptlball done
hm: fcacheall done

===> AVAIL_END = 128 Mbytes<===

btlb_insert(0): 0:0=0[200,2000002]
[ bsd ELF symbol table not valid: symtab unaligned ]
[ bsd symbol table has bad string table address 0x7fb32c4a ]
[ no symbol table formats found ]
hm: ddb_init done
hm: fcacheall done
init_main: config_init
init_main: consinit
consinit: enter, initted = 0
consinit: calling cninit, initted = 1
cninit: calling cn_probe
cninit: calling cn_init
consinit: exit, initted = 1
init_main: printf copyright
Copyright (c) 1982, 1986, 1989, 1991, 1993
	The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2003 OpenBSD. All rights reserved.  http://www.OpenBSD.org

init_main: uvm_init
init_main: disk_init
init_main: tty_init
init_main: cpu_startup
OpenBSD 3.4-current (RAMDISK) #56: Mon Oct  6 10:10:11 CEST 2003
    [email protected]:/usr/src/sys/arch/hppa/compile/RAMDISK
HP 9000/859/K220 (ThunderHawk DC3- 120 1M) PA-RISC 1.1a
real mem = 134217728 (524288 reserved for PROM, 8552448 used by OpenBSD)
avail mem = 108998656
using 8421 buffers containing 13393920 bytes of memory
init_main: mbinit
init_main: soinit
init_main: timeout_startup
init_main: sysctl_init
init_main: procinit
init_main: filedesc_init
init_main: filedesc_init
init_main: create swapper
init_main: rqinit
init_main: cpu_configure
mainbus0 (root) [flex fff80000]
btlb_insert(1): 0:fff80=fff80[80,1080002]
pdc0 at mainbus0
power0 at mainbus0: not available
lasi0 at mainbus0 offset fd00000 irq 86btlb_insert(2): 0:ffd00=ffd00[80,1080002]
: rev 3.0
gsc0 at lasi0
"LASI Bus Adapter" at gsc0 (type b, sv 81, hv 50) offset 0 not configured
osiop0 at gsc0 offset 6000 irq 86: NCR53C710 rev 2, 40MHz, SCSI ID 7
scsibus0 at osiop0: 8 targets
osiop0: target 0 now using 8 bit 10 MHz 8 REQ/ACK offset xfers
st0 at scsibus0 targ 0 lun 0: <HP, C1533A, 9608> SCSI2 1/sequential removable
st0: drive empty
osiop0: target 2 now using 8 bit 4 MHz 8 REQ/ACK offset xfers
cd0 at scsibus0 targ 2 lun 0: <TOSHIBA, CD-ROM XM-5401TA, 1036> SCSI2 5/cdrom removable
ie0 at gsc0 offset 7000 irq 87: LASI/i82596CA v1.0, address 08:00:09:d4:36:b8
lpt0 at gsc0 offset 2000 irq 88
"PS/2 port" at gsc0 (type a, sv 84, hv 50) offset 8000 not configured
"PS/2 port" at gsc0 (type a, sv 84, hv 50) offset 8100 not configured
"NCR 53C710 SCSI" at mainbus0 (type a, sv 82, hv 50) offset fd06000 not configured
"Core LAN" at mainbus0 (type a, sv 8a, hv 50) offset fd07000 not configured
"Core Centronics" at mainbus0 (type a, sv 74, hv 50) offset fd02000 not configured
"PS/2 port" at mainbus0 (type a, sv 84, hv 50) offset fd08000 not configured
"PS/2 port" at mainbus0 (type a, sv 84, hv 50) offset fd08100 not configured
"BC Runway Port" at mainbus0 (type c, sv b, hv 7) offset ff88000 not configured
"BC Runway Port" at mainbus0 (type c, sv b, hv 7) offset ff8a000 not configured
cpu0 at mainbus0 offset ffa0000 irq 31: PCXT' L1-B 120MHz, FPU PCXT' (Tornado) rev 1
cpu0: 1024K(32b/l) Icache, 1026K(32b/l) wr-back coherent Dcache, 120 coherent TLB, 16 BTLB
"PA-RISC" at mainbus0 (type 0, sv 4, hv c0) offset ffa2000 not configured
mem0 at mainbus0 offset ffb1000: size 1024MB
biomask 0x3 netmask 0x3 ttymask 0x13
init_main: uvm_init_limits
init_main: vfsinit
init_main: initclocks
clock.c, CPU_CLOCKUPDATE
init_main: Attach pseudo-devices
rd0: fixed, 5120 blocks
init_main: Initialize protocols
init_main: init_exec
init_main: scheduler_start
init_main: Mount the root file system
rootdev=0x300 rrootdev=0x900 rawdev=0x902
clock.c, inittodr: sec=1065428374, usec=0
init_main: uvm_swap_init
init_main: Create process 1
init_main: Create process 2
init_main: Create process 3
init_main: Create process 4
init_main: Create process 5
init_main: Create process 6
init_main: kthread_run_deferred_queue
init_main: microtime
init_main: srandom
init_main: scheduler
init: copying out path `/sbin/init' 11
erase ^?, werase ^W, kill ^U, intr ^C, status ^T
timeout delayed -4
timeout delayed -5
(I)nstall or (S)hell? S
# ls
.profile     etc          install.sub  sbin         var
timeout delayed -5
timeout delayed -6
timeout delayed -4
timeout delayed -5
timeout delayed -2
timeout delayed -2
bin          install      mnt          tmp
timeout delayed -3
timeout delayed -4
dev          install.md   mnt2         usr
timeout delayed -3
timeout delayed -4
timeout delayed -4
timeout delayed -5
timeout delayed -2
timeout delayed -2
#