Re: HP 9000 K200 (819) ...

> Date: Mon, 10 Dec 2007 13:15:13 -0500 (EST)
> From: Rob Sciuk <[email protected]>

> SPID bits: 0x0, error = -2
> pdc_coproc: 0xc0, 0xc0; model b rev 1
> [ bsd ELF symbol table not valid: symtab unaligned ]
> [ no symbol table formats found ]
> Copyright (c) 1982, 1986, 1989, 1991, 1993
>  	The Regents of the University of California.  All rights reserved.
> Copyright (c) 1995-2007 OpenBSD. All rights reserved.  http://www.OpenBSD.org
> 
> OpenBSD 4.2-current (RAMDISK) #546: Sun Nov 18 15:16:08 MST 2007
>      [email protected]:/usr/src/sys/arch/hppa/compile/RAMDISK
> HP 9000/819/K200 (KittyHawk DC2 100) PA-RISC 1.1a
> real mem = 536870912 (524288 reserved for PROM, 8269824 used by OpenBSD)
> avail mem = 517582848
> mainbus0 at root [flex fff80000]
> pdc0 at mainbus0
> power0 at mainbus0: not available
> biomask 0x3 netmask 0x3 ttymask 0x13
> bootpath: 10/12/5.2 class=1 flags=0 hpa=0xffd06000 spa=0x0 io=0xc000
> rd0: fixed, 5120 blocks
> root on rd0a swap on rd0b dump on rd0b
> WARNING: clock gained 21 days -- CHECK AND RESET THE DATE!

Hmm, I'm sure that machine has more hardware devices than this dmesg shows ;)

Looks like device enumeration simply fails on your machine.  I vaguely
remember seeing some Linux code that had some workarounds for firmware
calls for the KittyHawk.  I'll see if I can come up with a diff.

Meanwhile, could you try a verbose boot?  Say Y to the "Interact with
IPL?" question, then at the OpenBSD bootloader prompt type "boot -c
bsd.rd", and at the UKC> prompt say "verbose" and "quit".

Thanks,

Mark