Status of OpenBSD-hppa on 9000 D-class

Hi!  I was just wondering of the status of OpenBSD-hppa on 9000 D-class 
machines.  I attempted to install the latest -current snapshot on an 
9000/811/D210 and this is as far as I got:

--------

Boot IO Dependent Code (IODC) revision 2


HARD Booted.


 >> OpenBSD/hppa BOOT 0.8
boot>
booting lf0a:/bsd: 1607412+2699264+352256=0x6a9158
SPID bits: 0x0, error = -2
pdc_coproc: c0, c0
[ bsd ELF symbol table not valid: symtab unaligned ]
[ bsd symbol table has bad string table address 0x7fb3dc4a ]
[ no symbol table formats found ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
         The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2003 OpenBSD. All rights reserved.  http://www.OpenBSD.org

OpenBSD 3.3 (RAMDISK) #4: Thu Mar 27 14:22:32 EST 2003
     [email protected]:/usr/src/sys/arch/hppa/compile/RAMDISK
HP9000/811/D210/D310 (UltraLight Proc L-100) PA-RISC 1.1c
real mem = 67108864 (262144 reserved for PROM, 7499776 used by OpenBSD)
avail mem = 51032064
using 1630 buffers containing 6676480 bytes of memory
mainbus0 (root) [flex fff80000]
pdc0 at mainbus0
"WAX Bus Adapter" at mainbus0 (type b, sv 8e) offset fe00000 not configured
lasi0 at mainbus0 offset 100000 irq 28: rev 3.0
gsc0 at lasi0: wordleds
biomask 0x3 netmask 0x3 ttymask 0x13
rd0: fixed, 5120 blocks
rootdev=0x300 rrootdev=0x900 rawdev=0x902

--------

I just wanted to make sure that I didn't make an obvious error with the 
tftpd / bootp server.  The bsd errors at the top concern me.  Course - if 
this machine is not supported yet, then that would explain a lot.

Thanks!

Kris


---
[This E-mail scanned for viruses by Declude Virus]