Re: [OpenBSD 3.3/hppa] Install woes

Making, drinking tea and reading an opus magnum from Fonz:
> Hi there,
re
you are supposed to use -current.

and please do not attach multiple copies of signature
(does not matter how important it is for you) ...

cu

> I'm trying to install OpenBSD 3.3/hppa on a HP 712.
> 
> Bootstrapping, partitioning etc. are not a problem, but when it's time to
> fetch the distribution sets (FTP from a PC) I keep getting these messages
> every few seconds:
> 
>   e0: receive descriptors out of sync
>   ie0: reset
> 
> And occasionally, I get these:
>   d0(osiup0:6:0): command timed out
>   osiop0: resetting chip
>   osiop0: target 6 now using 8 bit 10 MHz 8 REQ/ACK offset xfers
> 
> Most of the sets can be fetched, it just takes ages. But the big one,
> base33, stalls before it even gets halfway.
> 
> I tried isolating the PC and HP from the rest of the network and I changed
> the (coax) cable, but that didn't help.
> 
> Any thoughts?
> 
> Someone over on misc@ suggested grabbing -current instead of 3.3, would
> that help?
> 
> Alphons
> 
> -- 
> A. van Werven                    http://www.liacs.nl/~avwerven
> Leiden Institute of Advanced Computer Science, The Netherlands
> Funny how they [women] always want to be friends after they rip
> your guts out.              -- from the movie Starship Troopers
> -- 
> A. van Werven                    http://www.liacs.nl/~avwerven
> Leiden Institute of Advanced Computer Science, The Netherlands
> Funny how they [women] always want to be friends after they rip
> your guts out.              -- from the movie Starship Troopers
> 


-- 
    paranoic mickey       (my employers have changed but, the name has remained)