Re: dev/console

On Fri, Jan 28, 2005 at 08:45:28PM -0800, Hugh Graham wrote:
> On Fri, Jan 28, 2005 at 09:45:57PM -0600, John Baker wrote:
> > I was able to get mu micro vax to boot from the OpenBSD that i have 
> > running on an i386 box.
> > It loads and all seems well until it gets to the end of this display code.
> > gooling hassn't been much help.
> > Any ideas on what could be causing it?
> 
> You need to set up your /export/vax directory.
> 
> tar xvzpf the base36/etc36 install sets under there, and run a
> sh MAKEDEV all in the /var/eport/vax/dev directory, set up
> the /var/export/vax/etc/fstab, set a root password and a few
> other things I'm probably forgetting and you should be good
> to go.

Unless you've actually got a disk in that thing and are trying
to install there, in which case put the bsd.rd into your export
dir and select that at the boot> prompt rather than the generic
kernel.

Should be straightforward from then on.

/Hugh