Re: Something wrong with MicroVAX m10e?

Hugo Villeneuve wrote:
> On Mon, Jun 20, 2005 at 07:46:13PM -0300, kroty wrote:
> 
>>Hi. I have a MicroVAX m10e. When I power it on, this
>>appear in the console
>>
>>KA 41-D V1.0
>>
>>F...E...D...C...B...A...9...7...6...5...4...3...2...1...
>>
>>  ?E 0040 0000.0005
>>  ?C 0080 0000.4001
>>  ?7 80A0 0000.4004
>>
>>VMS/VMB   ULTRIX  ADDR         NUMBYTES  RM/FX  WP  DEVNAM  REV
>>-------   ------  ----         --------  -----  --  ------  ---
>>ESA0      SE0     08-00-2B-1D-D8-92
>>
>>
>>...HostID.... A/6       INITR
>>DKB0 RZ8     B/0/0/90   DISK   665MB FX RZ56 0400
>>MKB500 TZ13  B/5/0/00   TAPE   ..... RM
>>...HostID....
>>
>>[ESA0:] ?>>>
>>
>>83 BOOT SYS
>>-ESA0
>>?54 RETRY
>>?54 RETRY
>>?54 RETRY
>>
>>I have a Digital VT340+ without keyboard.
>>Any idea on what's wrong? Thanks in advance.
> 
> 
> Is this a new behavior? You had it work correctly before? Or you
> are just putting into service, for the first time, a new acquisition?
> 
> Beside the failure to boot from the network, I don't see anything
> wrong.
> 
> Also, because of the failure, I would say it suggest a rarp, mop
> problem or maybe a failure to run openbsd boot code (boot.mop?).
> 
> A keyboard for input is a must. Although, you could get by with
> running diskless without one.
> 
> 
> 
It's a new acquisition, and my first VAX too :)
I just was expecting it to boot from the hd.