Re: Not Loading any X

I  set 'machdep.allowaperture=1'
> in /etc/sysctl.conf and reboot my notebook but my display goes to blank
screen!
Then, I can only power down by holdin power key!
How can I resolve this?

On Sun, Jun 14, 2015 at 12:24 PM, Raf Czlonka <[email protected]> wrote:

> On Sun, Jun 14, 2015 at 09:31:21AM BST, Mohammad BadieZadegan wrote:
>
> > Hi everybody,
>
> Hi Mohammad,
>
> > I have installed OpenBSD on my USB flash memstick and when I inserted
> > to my PC USB port its X loaded without any errors.
>
> If you're not using USB 3.0, the performance might be quite poor but I'm
> sure you already know that.
>
> > But when I'm going to reboot my notebook (DELL E6410) by my USB memstick
> > its X did not load and the file /var/log/Xorg.0.log contain these below
> log:
> >
> > ==========================================================
> >
> > /var/log/Xorg.0.log
> >
> >
> > [    50.440] (WW) checkDevMem: failed to open /dev/xf86 and /dev/mem
> > (Operation not permitted)
> > Check that you have set 'machdep.allowaperture=1'
> > in /etc/sysctl.conf and reboot your machine
> > refer to xf86(4) for details
>
> There's an advice at the top of the log file - try following it.
>
> Since it's an Nvidia GPU, I wouldn't expect anything better than VESA.
>
> Regards,
>
> Raf
>
>


-- 
[image: See you on my WEB] <http://933k.ir>