Re: Not Loading any X

I changed machdep.allowaperture to 2 after 1 and my blank screen did not
seen.
BTW, I connect other monitor to my notebook VGA port and see that the XDM
was loaded truely!
But now how can I get the XDM login screen on my notebook LCD (Not on VGA
port)?

On Sun, Jun 14, 2015 at 12:54 PM, Mohammad BadieZadegan <[email protected]
> wrote:

> I  set 'machdep.allowaperture=1'
> > in /etc/sysctl.conf and reboot my notebook but my display goes to blank
> screen!
> Then, I can only power down by holdin power key!
> How can I resolve this?
>
> On Sun, Jun 14, 2015 at 12:24 PM, Raf Czlonka <[email protected]> wrote:
>
>> On Sun, Jun 14, 2015 at 09:31:21AM BST, Mohammad BadieZadegan wrote:
>>
>> > Hi everybody,
>>
>> Hi Mohammad,
>>
>> > I have installed OpenBSD on my USB flash memstick and when I inserted
>> > to my PC USB port its X loaded without any errors.
>>
>> If you're not using USB 3.0, the performance might be quite poor but I'm
>> sure you already know that.
>>
>> > But when I'm going to reboot my notebook (DELL E6410) by my USB memstick
>> > its X did not load and the file /var/log/Xorg.0.log contain these below
>> log:
>> >
>> > ==========================================================
>> >
>> > /var/log/Xorg.0.log
>> >
>> >
>> > [    50.440] (WW) checkDevMem: failed to open /dev/xf86 and /dev/mem
>> > (Operation not permitted)
>> > Check that you have set 'machdep.allowaperture=1'
>> > in /etc/sysctl.conf and reboot your machine
>> > refer to xf86(4) for details
>>
>> There's an advice at the top of the log file - try following it.
>>
>> Since it's an Nvidia GPU, I wouldn't expect anything better than VESA.
>>
>> Regards,
>>
>> Raf
>>
>>


-- 
[image: See you on my WEB] <http://933k.ir>