Re: Qt3 and XFree86 4.2: Fatal IO error

I usually see "client killed" message when I ran out of memory.
maybe you are short of that?

frank

On Mon, 6 May 2002 [email protected] wrote:

> Hi
>
> I am using XFree86 4.2 and Qt3 from sourgeforge and I am getting occasional:
> "fatal IO error: client killed" from my Qt application. It seems to happen
> when I am displaying bitmaps (QLabel pixmap) in my application. It only
> happens very rarely (one out of ~100 times).
>
> I looked into the Qt source and found that the above error is outputted from
> the X fatal IO error handle (setup with XSetIOErrorHandler()).
>
> Any ideas?
>
> It does not seem to happen under XPhoton, so I might have to go back to
> XPhoton if I can't figure this out.
>
> Thanks
> Jens
>
>