RE: Qt3 and XFree86 4.2: Fatal IO error

Hi Frank

Thanks for the suggestion - but it does not seem to be a memory problem as I
got 70 MB free (reported by "pidin info") when it happens.

I also realized that it does not seem to be related to bitmap displaying -
it also happens with other dialogs. The program gets killed when
QDialog::exec() is called.
--
Jens

-----Original Message-----
From: Frank Liu [mailto:[email protected]]
Sent: Monday, May 06, 2002 5:54 PM
To: [email protected]
Cc: openqnx-developer-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org
Subject: Re: [Openqnx-developer] Qt3 and XFree86 4.2: Fatal IO error



I usually see "client killed" message when I ran out of memory.
maybe you are short of that?

frank

On Mon, 6 May 2002 [email protected] wrote:

> Hi
>
> I am using XFree86 4.2 and Qt3 from sourgeforge and I am getting
occasional:
> "fatal IO error: client killed" from my Qt application. It seems to happen
> when I am displaying bitmaps (QLabel pixmap) in my application. It only
> happens very rarely (one out of ~100 times).
>
> I looked into the Qt source and found that the above error is outputted
from
> the X fatal IO error handle (setup with XSetIOErrorHandler()).
>
> Any ideas?
>
> It does not seem to happen under XPhoton, so I might have to go back to
> XPhoton if I can't figure this out.
>
> Thanks
> Jens
>
>