Re: Blade 1000 not booting up

On Nov 18, 2007 10:52 PM, Fabio A. Miranda
<[email protected]> wrote:
> Hello,
>
> I have a Sun blade 1000 workstation, when I turn it on, the Sun logo
> light up, but after 3 seconds, suddenly, the machine is power off.
>
> What's the cause of this behavior ? is this a classic power supply failure ?

Actually sounds more like the chassis interlock is disengaged. Make
sure the side panel of the SB1000 is firmly seated in place before
your next power-on attempt.

Also, have you attempted to connect a console device (terminal, or
another host running a terminal emulator like HyperTerm/PuTTY) to
serial port A to read the output prior to the shutdown?

Hope that helps,

-A