Re: Re: Problems installing Solaris 10 10/08 on Sun Ultra 30
Cody Swanson <[email protected]>
| Newsgroups | gmane.os.solaris.at-home |
|---|---|
| Message-ID | <[email protected]> |
Pete wrote: > > > Alexandre Lagüe-Jacques wrote: >> The diagnostic mode indicates that everything is fine. >> >> I hadn't even thought of the CPU. Considering that it boots NetBSD, I >> couldn't imagine that there could be a hardware problem. Just to be >> sure, I pulled an old 250 MHz processor module out of a box and sure >> enough Solaris generated the key and booted! So thanks! >> >> It was insufferably slow so I replaced the 300 MHz module and it runs >> fine, given that the key was already generated (I suppose). Of >> course, running a potentially defective CPU is worrying! Any idea if >> it's possibly to test the CPU for a defect? > > The key generation is very cpu intensive so, I would guess it is over > heating and shutting down. The rest of the install the cpu is > basically doing nothing. > > You could carefully disassemble the cpu module and redo all heat sink > compound but, I wouldn't bother. You should be able to pick up a used > 450mhz cpu for almost nothing. They sell for about $5 each on eBay > last I looked. > _______________________________________________ > Suns-at-Home mailing list > [email protected] > http://www.net-kitchen.com/mailman/listinfo/suns-at-home > Agreed, at my work I maintain a bunch of older ultrasparc machines and I've encountered this problem before, the cpu compound between the cpu and heat sink dries up and gets cracked. I've solved the problem by carefully removing the CPU and applying Artic Silver. Although, if you can find a 450mhz processor that would be the way to go..