ARB issues

Ahh, yes you do need to move the ARB to use wide wheels (no chassis mods
though) and moving it down under the chassis is the easiest way.

The one on my car has two alloy blocks that bolt to the flat plate to either
side of the fuel tank just behind the last lateral lower chassis bar (behind
de-dion tube). the kit should be easy enough to fit.

Guy

Subject: RE: [Sevens] 7 or 8 inches sir? (Or madam) :-)
Message-ID:
<[email protected]>
Content-Type: text/plain
MIME-Version: 1.0
Precedence: list
Reply-To: [email protected]
Message: 14

> How easy is the underslung one to fit? Requires a visit to Arch? 
> Likelihood that the mods, if any, can be done here in Finland easily?

Yeah should be a piece of p*ss.  I looked into doing it before I talked to
Freestyle.  There are a pair of small tubes brazed through the lower chassis
rails just behind where the A frame mounts to the chassis.  These tubes take
a couple of bolts that attach the alloy blocks to the chassis.  Only problem
is where they are along the rail.  But it's not critical for an ARB and if
you have the bar offered up to the chassis it'll be pretty obvious where it
should go.  Plus I'm sure some kind lister could measure his chassis and let
you know.
-------------------------------------------------
To manage your subscription options visit :-
http://mailman.se7ens.net/mailman/listinfo/sevens