Re: Questions about BC250D or ARC250

I have reloaded it several times.  As far as I can tell it is set up
as a trunking bank but it is acting like it is not.  How do I set a
bank as a trunking bank or check it, either from the radio or arc250?
 I figured that if I set the trunking system and associated
parameters, then that told it that this is a trunking bank.

Not sure if I have a tag list.  I have tags entered into tag banks and
assigned names.  Is that the tag list, or is there a tag list that
lists the tag banks?  I'm confused on this part.  Thanks!

Yes, I do see the signal strength, and is typically full strength.



--- In [email protected], llpix@... wrote:
>
> 
>  I would set up the bank again and this time, program it as a
trunked bank as opposed to conventional.
> ?next, from menu I would hit option 3 and enter my tg list and tag
them as well.
> Of course, hit "done" when finished.
> When you turn the scanner on, it should just scan and be able to
work fine for you.? To test it out I would unlock all tg just to see
if you are getting anything.
> 
> Question. when you are in scan mode, do you see the signal strength
meter at all, or do you have a weak control channel signal. 
> 
> Alex
> 
> 
>  
> 
> 
>  
> 
> 
> 
> 
> 
> 
> 
>  
> 
> 
> 
> [Non-text portions of this message have been removed]
>