Re: Need help programing Trunking

--- In [email protected], "Pat Thomas" <patnkim1@...> wrote:
>
> I'm assuming since you posted here you're using the BC250. Since the 
> system you are trying to listen to is digital do you have the BCi25D 
> card installed in your scanner?




*************
Yes I have it installed and runnning. I know it's working because I
can listen to JC fine (conventional)
and yes it is the BC250D
*************



--- In [email protected], llpix@... wrote:
>
> 
>  
> 
> 
>  Set the scanner for uhf trunking moto and see if that works.
> Once you have the freq in hit search to see if you have any talk
groups. If you do, make note of what they are. You must have the base
and offset programmed in as well.
> ?If you get nothing, then it might be edacs which you will need the
logical channel order. What are you trying to scan??


*************

I dont know what the Base, spaceing, or channel offset is. I haven't
messed with trunking so I have no clue

um.... ok here is what I do from step to step
Clr all memories in Bank 4 (301-400)
enter and save Freq.
in this order:
453.81250   453.32500 	453.48750 	453.58750 	453.61250   453.23750  
453.92500 	460.16250 	460.18750       460.23750 	460.31250

notice I put the primary first and moved the First one in the spot of
the primary (#6) so that was probly wrong?

then
Menu/back + 2 + 2 select bank 4 
Trunk Type, on, Type2 UHF, "Select base conf" (selected Base config 1)
Enter the Primary Frequncy 
453.81250
step I changed to 25.0 
offset at 380 (unchanged)
*-* Leave this menu *-*
Talk Group
in M1-1 Entered
1-1: 20001
1-2: 20051
1-3: 20101
1-4: 20007
1-5: 20059
1-6: 20003
1-7: 20009
1-8: 20013
1-9: 20015
1-0: 20017
2-1: 20051
2-2: 20061
2-3: 20069
Menu/Back
ID list Tags left blank
Menu/back 
Activity ID ON
I call: OFF     Status bit: On Endcode: detect
now I just hit scan. and it goes over and over and over and over again.

now I noticed in manule scan that 301 Only has "C" above it and the
Rest in the bank have "M"
Some other channels are full RF but it's not stopping the scan
Now If scann is on and it stops on 301 I can Hear fine (p25 is being
activated) but it's not listing to other channels. I know for sure
there is more activity out there. what am I doing wrong?

*************