Re: Re: (no subject)

Ok Brian, looking at this fiasco a little deeper my last rant was uncalled
for as you had explained to me in an earlier email that you had a hard time
finding the frequency data for your city on Radio Reference but when you
sent me to your other frequency page, I was able to match up *their* data on
Radio Reference.

It looks like the system you're trying to program is a Motorola type II UHF
and the spacing is 12.5 which ARC250 will assign for you. However you need
to enter *all* of the below frequencies into *one bank* and you need to have
*all* the frequencies entered, not just the control channel frequency:

*102 South Simulcast 866.17500 866.23750 866.41250 866.46250 866.87500
867.08750 867.15000 867.23750 867.45000 *
*867.92500a 868.17500a 868.41250a 868.87500c   *
**
http://www.radioreference.com/apps/db/?sid=4275

Try that and we'll take it from there....good luck!

-Roger
**
**
**
**

On Wed, Jan 21, 2009 at 5:13 PM, brian.daniels12 <[email protected]> wrote:
> Ok, were getting closer. I have managed to connect the scanner to my
> desktop computer and the little devil came to life for a brief
> second. I heard what I can only assume was a call by my local PD as
> it mentions a local bank. I was only half done programing the scanner
> and it has once again gone silent. A couple of ARC250 questions. For
> a frequency of 868.875 what "mode" should I be in? It is in NFM now.
> Should I go to FM? The step is set at "12.5". Should it be set
> at "auto"? Those two parameters sort of set themselves up as I
> programed in the frequencies. Also my frequency list includes a
> control channel. The most obvious band is "Motorola Type 2 800mhz".
> Does this sound correct? The "M" does appear before the channel
> number so I think I got that right. Again thanks for any help. I will
> attempt to attach a link to the site I found my frequencies. Brian
>
> http://www.rfwiz.com/Frequencies/RhodeIsland/RI_TownsCounties.htm
>


[Non-text portions of this message have been removed]