Re: Re: (no subject)

Oh! This and might help you too. When using ARC250 to program go to the
TRUNK>SYSTEM SETTINGS and choose the trunking system\bank you want to
program. After you do that, start entering the frequencies and tag
information *only*. When you're done entering the frequency and tag
information go to OPTIONS>CHECK DATA IN TABLE USING BAND PLAN>CURRENT BANK.
This will fill the data in for you *automatically* and is about 99%
accurate.

-Roger

On Wed, Jan 21, 2009 at 5:13 PM, brian.daniels12 <[email protected]> wrote:
>
> Ok, were getting closer. I have managed to connect the scanner to my
> desktop computer and the little devil came to life for a brief
> second. I heard what I can only assume was a call by my local PD as
> it mentions a local bank. I was only half done programing the scanner
> and it has once again gone silent. A couple of ARC250 questions. For
> a frequency of 868.875 what "mode" should I be in? It is in NFM now.
> Should I go to FM? The step is set at "12.5". Should it be set
> at "auto"? Those two parameters sort of set themselves up as I
> programed in the frequencies. Also my frequency list includes a
> control channel. The most obvious band is "Motorola Type 2 800mhz".
> Does this sound correct? The "M" does appear before the channel
> number so I think I got that right. Again thanks for any help. I will
> attempt to attach a link to the site I found my frequencies. Brian


[Non-text portions of this message have been removed]