Re: Re: Need help progaming

Did you change it to custom band plan? 
Even with the most recent firmware 3.02.02 my scanner still needed the new re-banded frequencies AND the custom band plan.  If memory serves me correctly the software, in the bandplan settings, says re-banding bandplan.   

Double check that and feel free to email me off list if necessary.   


_____________________________________
Sprint Treo Pro
Blackberry 8900 PIN 24A9DE71
PDA Repair - Blackberry, Treo, Windows Mobile
Motorola 2-Way Radio Service and Technical Consulting
http://www.twowayshopper.com

-----Original Message-----
From: "Ken Weimer" <[email protected]>
Date: Fri, 5 Feb 2010 23:17:14 
To: <[email protected]>
Subject: Re: [UnidenBC250D] Re: Need help progaming

Patrick,
I completed the Uniden firmware upgrade as outlined by Uniden and received message to the effect that upgrade was succcessful. I am signed up on the 396T list and did receive a few suggestions which did not work out.  I have tried three different programs:  1st, the ScanControl 7.1.0 which worked well with my 250, but not with the 396T.  I then tried the trial version of ProScan 3.1.0....no success.  Then ARC396Pro Demo Version.  No success, although I was impressed with the ARC396 program.  Appeared to get the frequencies in, but still zero reception....I did get infrequent skip signals from Arizona (I am in Conyers, Ga)...so I knew scanner was working.  This all around August of last year.  After a long day of work and then dealing with studies from a Online Distant Learning school (rela
 ted to my job) and getting behind on studies, I just didn't have the time to continue to deal with trying to program the 396T.  It has gathered dust since August.  A work acquaintance sent his 396T to a programmer (I believe Scanner Master) which cost him $150 to program for our local system.  I told him I was determined to do my own programmming...but, to date, that has not happened.  I do appreciate the interest yahoogroups has shown in helping me with this problem.  Maybe in another month or so I will have time to get back into dealing with programming the 396T...meanwhile, back to my studies.

Ken    


----- Original Message ----- 
  From: Patrick - Used 2-Way 
  To: [email protected] 
  Sent: Friday, February 05, 2010 9:28 AM
  Subject: RE: [UnidenBC250D] Re: Need help progaming


    
  Not sure where to start with this one. 




[Non-text portions of this message have been removed]




[Non-text portions of this message have been removed]