Tip: different steps in top and bottom band edges

Say we are programming scan edges into registers 5A and 5B.  Well, we
could say, put a 25 kHz step on 5A, and a 50 kHz step into 5B. That
way any time we want to scan P5 in 25 kHz steps, with 5A on the
display, we would press BAND, copying 5A into the VFO. We would then
hit FUNC + BAND to select PROG 5, unless already selected, and hit
FUNC + an ARROW to start the scan.  Likewise for 50 kHz on 5B.



------------------------ Yahoo! Groups Sponsor --------------------~--> 
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/ELTolB/TM
--------------------------------------------------------------------~-> 

Post message:   [email protected] 
Subscribe:      [email protected] 
Unsubscribe:    [email protected] 
List owner:     [email protected] 
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
     http://groups.yahoo.com/group/icomr2/

<*> To unsubscribe from this group, send an email to:
     [email protected]

<*> Your use of Yahoo! Groups is subject to:
     http://docs.yahoo.com/info/terms/