Re: tk2 v0.9 open source software for ICOM IC-R2 available
Thor Heglund <jmakrl-yBeKhBN/[email protected]>
| Newsgroups | gmane.recreation.radio.hardware.icomr2 |
|---|---|
| Message-ID | <[email protected]> |
Hey Bob, I'm trying to get tk2 to work in linux. I've installed the most recent tcl/tk, downloaded tk2 v0.9, and followed the instructions on your page. The program starts up, asks for the serial port, but when I read from the radio it just hangs, the radio display never says CL OUT. My serial port is on ttyS0 (dmesg says: ttyS0 at 0x03f8 (irq = 4) is a 16550A). I've double checked the write permissions on ttyS0, they're correct. I'm kind of new to linux so perhaps I'm missing something obvious. It works fine in windows. I suspect it may be an issue with my serial port and not your software but I was wondering if you might have any suggestions. Thanks, Thor Post message: [email protected] Subscribe: [email protected] Unsubscribe: [email protected] List owner: [email protected] Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/