Re: tk2 v0.9 open source software for ICOM IC-R2 available
"Bob Parnass, AJ9S" <yahoo-V4/[email protected]>
| Newsgroups | gmane.recreation.radio.hardware.icomr2 |
|---|---|
| Message-ID | <[email protected]> |
Hi Thor, 1) Are you sure that /dev/ttyS0 is the correct device for the serial port connector on you computer? 2) What cable/level converter are you using to connect the PC to the IC-R2? 3) Which distribution of Linux are you using? 4) In a Linux command window, type: uname -a ls -l /dev/ttyS0 What are the results? 5) Connect the radio to the PC and turn the radio on (use battery power). Remove the $HOME/.tk2rc file. Start tk2 and select the proper serial port. In tk2, use the "Radio --> Interrogate Radio for Model Info" command. After using this command, what is displayed in the Radio Version field in the Secondary Controls window? Thanks. On Wednesday 05 March 2003 04:06 pm, Thor Heglund wrote: >... My serial > port is on ttyS0 (dmesg says: ttyS0 at 0x03f8 (irq = 4) is a 16550A). > I've double checked the write permissions on ttyS0, they're correct. I'm > kind of new to linux so perhaps I'm missing something obvious. It works > fine in windows. I suspect it may be an issue with my serial port and > not your software but I was wondering if you might have any suggestions. -- ========================================================================= Bob Parnass, AJ9S Linux User http://parnass.com Post message: [email protected] Subscribe: [email protected] Unsubscribe: [email protected] List owner: [email protected] Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/