Re: Losing signal on uhf

Joey,
Is the signal reception affected by pressing the R2's antenna against 
something? If so, your SMA center-pin connector may have broken from 
the circuit board. Mine did (probably from a drop), and I had to re-
solder the center pin of the SMA connector to the circuit board. Not a 
hard fix.

Good luck,
Albert

> I have noticed that when listening to my local pd on uhf the signal is
> received and then the signal just goes right out and then comes right 
back
> in.  It seems like the uhf signals like to come and go.  I thought it 
was
> because I was carrying the scanner on my side but I have noticed that 
with
> it sitting on the table it does that sometimes.  It does not do it 
all the
> time.  And more strangely it only does it on uhf and not vhf?  Has 
this
> happened to any one else?  If so what steps did you do to correct it?






------------------------ Yahoo! Groups Sponsor --------------------~--> 
Get fast access to your favorite Yahoo! Groups. Make Yahoo! your home page
http://us.click.yahoo.com/dpRU5A/wUILAA/yQLSAA/ELTolB/TM
--------------------------------------------------------------------~-> 

Post message:   [email protected] 
Subscribe:      [email protected] 
Unsubscribe:    [email protected] 

 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/icomr2/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/