Re: scanning ctcss

Hi

I have done that, but when i hit the scan button it still stops on the freq and the radio starts to trawl the ctcss's until it finds the correct one.

I'm after hitting the scan button and it stopping on the correct freq' with the correct ctcss, without it scrolling through them all until the correct one is found.

Does that make sence?

Regards

  ----- Original Message ----- 
  From: Chuck Rapacki 
  To: [email protected] 
  Sent: Wednesday, February 09, 2011 6:52 PM
  Subject: Re: [UnidenBC780XLT] scanning ctcss


    


  Hit menu, then 2, enter the channel number that the freq is on & hit E (Enter). 
  Then hit 3 for Tone Data, then hit 1 for CTCSS, then arrow up or down to pick 
  the propper CTCSS (PL) tone. Hit enter when you find the right code. Now you 
  should only hear that freq with that tone only. 

   Chuck in Detroit / NODAK 1
  [email protected]

  ________________________________
  From: scrunge <[email protected]>
  To: [email protected]
  Sent: Wed, February 9, 2011 12:52:39 PM
  Subject: [UnidenBC780XLT] scanning ctcss

    
  Greetings

  How do I set the scanner to search my stored freq's by ctcss?
  I have 6 people on the same freq and all with different ctcss.

  How do I switch on scanning and it stopping on the correct freq and tone?

  Regards

  [Non-text portions of this message have been removed]

  __________________________________________________________
  Need Mail bonding?
  Go to the Yahoo! Mail Q&A for great tips from Yahoo! Answers users.
  http://answers.yahoo.com/dir/?link=list&sid=396546091

  [Non-text portions of this message have been removed]



  

[Non-text portions of this message have been removed]