Re: 785D configuration

Thanks Doc.....The problem was the PC CONTROL setting.

73,

Dave KD8AMR

On 3/16/2005 10:31:09 PM, [email protected] wrote:
> No special cable, be certain the scanner menu item indicates the scanner
> is in PC CONTROL and of course that the correct COM port is selected.
>
> ----- Original Message -----
>
> From: Dave
>
> To: [email protected]
>
> Sent: Wednesday, March 16, 2005 6:02 PM
>
> Subject: [UnidenBC785D] 785D configuration
>
>
>
>
>
>
>
>
>
> Hi all,
>
>
>
> I have a new 785D with the APCO card.
> I'm trying to program from my
> PC and I have the Bearcat E-scanner plus program. The PC and the
> radio aren't
> recognizing each other. I'm using a shielded RS-232C
> cable from Radio Shack for the connection. Is this the right cable,
> or is there some "special" 232 cable required?
>
> Thanks.....
>
> Dave
>
>
>
>
>
>
>
>
> If you have come here to find out about the 785D you have come to the
right place! In fact the discussion of the BC-785D and how it works is the
only acceptable topic on this list. Any discussion about anything other than
the BC-785D is OFF TOPIC. I hope this is clear to all group members..
>
>
> Community email addresses:
> UnidenBC78




If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..