Re: 785D configuration

"emarchandearl" <emarchandearl-FFYn/[email protected]> Mon, 16 May 2005 15:53:31 -0000

Newsgroups	gmane.recreation.radio.hardware.uniden.bc785d
Message-ID	<[email protected]>

--- In [email protected], "Dave" <capn2@c...> wrote:
> set your baud rate to 9600
> 
> Hi all,
> 
> I have a new 785D with the APCO card.  I'm trying to program from my 
> PC and I have the Bearcat E-scanner plus program.  The PC and the 
> radio aren't recognizing each other.  I'm using a shielded RS-232C 
> cable from Radio Shack for the connection.  Is this the right cable, 
> or is there some "special" 232 cable required?
> 
> Thanks.....
> 
> Dave

If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..