Re: Re: 785D configuration

I know this has happened to me make sure PC control is
enabled under system option
--- emarchandearl <emarchandearl-FFYn/[email protected]> wrote:
> --- In [email protected], "Dave"
> <capn2@c...> wrote:
> > set your baud rate to 9600
> > 
> > Hi all,
> > 
> > I have a new 785D with the APCO card.  I'm trying
> to program from my 
> > PC and I have the Bearcat E-scanner plus program. 
> The PC and the 
> > radio aren't recognizing each other.  I'm using a
> shielded RS-232C 
> > cable from Radio Shack for the connection.  Is
> this the right cable, 
> > or is there some "special" 232 cable required?
> > 
> > Thanks.....
> > 
> > Dave
> 
> 
> 


		
__________________________________ 
Yahoo! Mail Mobile 
Take Yahoo! Mail with you! Check email on your mobile phone. 
http://mobile.yahoo.com/learn/mail 


If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..