Re: leaving channels early

Sounds like you have a negative delay set on some channels. That means 
it will only stay on that channel X seconds.

Or, it could be the data skip function. I don't recall if the 785 had 
that or not.

Joe M.

[email protected] wrote:
> Anyone else have the following problem:
>  
> Programmed my 785 via computer a few years back. I have it in the car.  
> Seems on some channels that are "delayed" will start scanning again in the  
> middle of a sentence. Have checked power connections--antenna etc but can't 
> find  a problem there ;-(
>  
>  
>  
> 73'
> 
> Bob
> WB3DYE
> 
> [Non-text portions of this message have been removed]
> 
> 
> 
> ------------------------------------
> 
> If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..
> 
> 
> Community email addresses:
> [email protected]
> 
> Yahoo! Groups Links
> 
> 
> 
> 


------------------------------------

If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..