Re: leaving channels early

Check for the -delay (negative delay) on the channel.


----- Original Message ----- 
From: <[email protected]>
To: <[email protected]>
Sent: Saturday, November 05, 2011 10:03 AM
Subject: [UnidenBC785D] leaving channels early


> Anyone else have the following problem:
>
> Programmed my 785 via computer a few years back. I have it in the car.
> Seems on some channels that are "delayed" will start scanning again in the
> middle of a sentence. Have checked power connections--antenna etc but 
> can't
> find  a problem there ;-(
>
>
>
> 73'
>
> Bob
> WB3DYE
>
> [Non-text portions of this message have been removed]
>
>
>
> ------------------------------------
>
> If you have come here to find out about the 785D you have come to the 
> right place! In fact the discussion of the BC-785D and how it works is the 
> only acceptable topic on this list. Any discussion about anything other 
> than the BC-785D is OFF TOPIC. I hope this is clear to all group members..
>
>
> Community email addresses:
> [email protected]
>
> Yahoo! Groups Links
>
>
>
> 



------------------------------------

If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..