Re: Uniden 785 XLT

I hi the bank numbers while it is scanning and they turn on then.
 
 
In a message dated 4/21/2013 10:26:31 P.M. Eastern Standard Time,  
[email protected] writes:

 
 
 
Hi Guys. A long time since i posted on here,i need a little help if anyone  
can help,could anyone tell me how to program channels into banks,every time 
i  instigate a scan,it will begin to scan with bank 1 flashing,but how do 
you get  from bank 1 to bank 2,because when i do try it the figure 2 just 
disappears  from the screen and leaves just an hyphen in its place,this happens 
to bank  4/5/6/and so on,any help would be appreciated.

Colin






[Non-text portions of this message have been removed]



------------------------------------

If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..