Re: ID Search of EDACS system.

Are the LCNs in the correct order and is the control channel receiving 
a  signal ?
Hold on the control channel and do you hear the control channel noise ?

Clark

At 10:51 AM 5/4/2013, you wrote:

>I just programmed an EDACS system into my BC785. However when I try an ID 
>SEARCH it never stops on any talk-group.  I know there are talk-groups 
>active because I have a BC780XLT also in ID SEARCH and its finding & 
>stopping on every talk-group that's active.
>
>What am I doing wrong on the BC785 while trying ID SEARCH on an EDACS system.
>
>Thanks
>George
>http://www.MilAirComms.com



------------------------------------

If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..