Re: Select Specific Frequency

Thanks to all who responded to my question.  I posted a similar 
question on the arc250pro group asking if it could be done via the 
Virtual Control portion of that software and got the following 
response from Gommert:

"Only in ARC250PRO. Select 'Misc' tab and there is a vfo frame where
you enter a frequency. If you use basic you just enter a freq in a
channel.

Gommert
www.butelsoftware.com"

Tried that and it works SLICK, so problem solved.  I think the 
software stores it in Channel 999 or 1000, as someone else suggested, 
but it's lots easier to manage the scanner via ARC250PRO than 
manually anyhow.

Thanks again.




------------------------ Yahoo! Groups Sponsor --------------------~--> 
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/DLTolB/TM
--------------------------------------------------------------------~-> 

If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..