Newbie Question..
"Jeff" <[email protected]>
| Newsgroups | gmane.recreation.radio.hardware.uniden.bc785d |
|---|---|
| Message-ID | <[email protected]> |
Just started programming my new 785d after many years of using conventional based scanners and have found that only bank 1 will trunk. I programmed bank 10 for a seperate trunking fleet and none of group id's will come up. It doesen't even seem to trunk properly usiong bank 10. It's an EDACS system I'm trying to program and I have the frequencies in the right order and programmed it in the same manner as the first bank and have ensured the id's for that group are in the id scan. Any suggestions?? ------------------------ Yahoo! Groups Sponsor --------------------~--> $9.95 domain names from Yahoo!. Register anything. http://us.click.yahoo.com/J8kdrA/y20IAA/yQLSAA/DLTolB/TM --------------------------------------------------------------------~-> If you have come here to find out about the 785D you have come to the right place! In fact the discussion of the BC-785D and how it works is the only acceptable topic on this list. Any discussion about anything other than the BC-785D is OFF TOPIC. I hope this is clear to all group members..