Re: Clipping
| Newsgroups | gmane.recreation.radio.hardware.yaesu.ft100 |
|---|---|
| Message-ID | <557D110383EAA23C.9e37ca83-019f-4865-a8a7-d02a9ee609a5@mail.outlook.com> |
Hi Rick and thanks for the reply. I am using a standard microphone. Have you any specific settings you could recommend ? Thanks in advance. Chris Regards Chris On Mon, Jul 22, 2019 at 9:48 PM +0100, "Rick Booth [email protected] [FT100]" <[email protected]> wrote: Low voltage is possible but if you have over 13 volts of DC input "under load" then it is not likely unless a circuit failure has occurred that results in increased gain or output swing of the audio. Too high of microphone gain can cause clipping. There is a speech processor built into the FT100 that may not have the parameters set correctly. Rick w6nzk On 7/22/2019 12:26 AM, [email protected] [FT100] wrote: Hi David is there a fix for this ? Regards Chris On Mon, Jul 22, 2019 at 8:18 AM +0100, "david.browne7-XZoyATsUNX5Wk0Htik3J/[email protected] [FT100]" <[email protected]> wrote: Low voltage On 22 Jul 2019 7:37 am, "[email protected] [FT100]" <[email protected]> wrote: Hi group. I have been told that my speech may be clipping on the Ft100. Has anyone got any clues ? Regards Chris