RE: Re: A couple of general questions about the VR-500

H,

Yep, sure can!! I have done it and it works just fine. I remove about 1/2" of one battery cover and put it in the 'bottom' spot. 

 

Works good.

 

Oliver

ZL3OOC
 


To: [email protected]
From: [email protected]
Date: Thu, 24 Dec 2009 22:11:02 +0000
Subject: [VR-500] Re: A couple of general questions about the VR-500

  



The VR-500 senses the presence of the rechargeable pack through contact of the metal finger at the bottom right of the battery compartment with the exposed lower casing of the cell closest to the bottom. It is possible to enable charging of any AA rechargeables by removing a "window" of insulation from one of the cells and allowing it's metal casing to make contact with the sense terminal. 

Voi 

--- In [email protected], "W3FIS" <deadgoose@...> wrote:
>
> Ok, one more....
> 
> If I use the rechargable battery pack, I assume the system senses that it is a rerchargable pack, not the AA batteries.
> 
> Somebody on the group raised the issue about a 30 mA charging rate... that is the trickle rate on my FT-817ND. I "float" the FT-817ND on line all the time. ONLY if I am doing extended QSOs or net control, is there any indication that I'm running the battery down. Since I run the rig maybe an hour a day, I have 23 hours at 30 ma to recharge, which seems more than sufficient.
> 
> Any thoughts??
> 
> /paul W3FIS
>




 		 	   		  
_________________________________________________________________
Find a way to cure that travel bug MSN NZ Travel
http://travel.msn.co.nz/

[Non-text portions of this message have been removed]