Re: Re: Cannot connect to PC

There is a guy in the UK who does a programme for about £10.00 i used it and its ok,but you do have to get a cable,mine came off ebay.

Colin




________________________________
 From: "[email protected]" <[email protected]>
To: [email protected] 
Sent: Sunday, 23 June 2013, 18:44
Subject: Re: [YaesuVR-5000] Re: Cannot connect to PC
 


  
On 23 Jun 2013 at 11:58, [email protected] wrote:

> On 23 Jun 2013 at 11:17, gingergrowler wrote:
> 
> > Hi there,
> > Yes it's deffo the correct cable I've triple checked.
> 
> But you don't say what cable you used.  It's been several years since I've used the VR-5000, but if I remember 
> right, the manual was at best ambiguous, to the extent of being wrong. 

I searched and found my old manual, and refreshed my memory re why I thought the manual was ambiguous.
On the page where they discuss the CAT, in the text, it says "Purchase a standard  serial cable (not the so called 
"null modem" type".    This is wrong.  Down below that is a diagram, showing the receiver connected to an 
"RS-232 cross cable".  This is correct.  A null modem cable is a cross cable which also contains a bunch of 
handshaking lines.  The handshaking lines aren't used by the VR5000, so a null modem cable will work fine, as 
will a cross cable that just has the S/R/Gnd lines only. 

Anyway, the text part of the manual is wrong, but the diagram is right, so if you were triple checking via the text, 
that could be the problem. 


 

[Non-text portions of this message have been removed]