Auto storage of frequencies

Hi,

I posted this message to the other VR120 group as well.
I am planning to buy a VR120, but have a question:

By reading the manual I see that it is possible to program a lower and
upper limit and let the VR120 perform a 'sweep' between these
frequencies. Any found active
frequency will be stored in a channel. This can be a nice feature if
you want to search
for active frequncies between the two limits.

However, if I read the manual right, this 'sweep' is only performed
once, right?
What's the use of it then? If there is no active frequency when the
sweep is
performed, no frequency will be stored.

Is there no way to let the VR120 perform this sweep constantly?
It would be great if you could let the VR120 search a whole day
between these
two limits. In the evening you could check the active frequncies.

So in short: Is it possible to let the VR120 search between two limits
and store
the found active frequencies for a longer period of time?

Thanks,
/Marc


------------------------ Yahoo! Groups Sponsor ---------------------~-->
Buy Ink Cartridges or Refill Kits for Your HP, Epson, Canon or Lexmark
Printer at Myinks.com. Free s/h on orders $50 or more to the US & Canada. http://www.c1tracking.com/l.asp?cid=5511
http://us.click.yahoo.com/l.m7sD/LIdGAA/qnsNAA/ELTolB/TM
---------------------------------------------------------------------~->

To unsubscribe from this group, send an email to:
Post message:        [email protected] 
Subscribe:           [email protected] 
Unsubscribe:         [email protected] 
List owner:          [email protected] 

 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/