Failed to add Position Sensor to channel!
"H.S. Randhawa" <[email protected]> Mon, 20 Mar 2006 14:55:42 +0530
| Newsgroups | gmane.science.robotics.orocos.user |
|---|---|
| Message-ID | <[email protected]> |
I tried to add Position Sensor to channel. but it is not taking it. the results shows as in your axis control program ie Failed to add Position Sensor to channel! plz guide me in this regard _______________________________________________ Orocos mailing list [email protected] http://lists.mech.kuleuven.be/mailman/listinfo/orocos