Re: Failed to add Position Sensor to channel!

Herman Bruyninckx <[email protected]> Mon, 20 Mar 2006 10:29:15 +0100 (CET)

Newsgroups	gmane.science.robotics.orocos.user
Message-ID	<[email protected]>

On Mon, 20 Mar 2006, H.S. Randhawa wrote:

> I tried to add Position Sensor to channel. but it is not taking it.
> the results shows as in your axis control program ie Failed to add Position
> Sensor to channel!
>
> plz guide me in this regard
>
You give tremendously little information... Plz help us in this regard :-)

Herman

--
   K.U.Leuven, Mechanical Eng.,  Mechatronics & Robotics Research Group
     <http://people.mech.kuleuven.be/~bruyninc> Tel: +32 16 322480

Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm

_______________________________________________
Orocos mailing list
[email protected]
http://lists.mech.kuleuven.be/mailman/listinfo/orocos

Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm