Re: New TV Tuner cards ??
William Case <[email protected]>
| Newsgroups | gmane.user-groups.linux.ottawa.general |
|---|---|
| Message-ID | <1217203768.32649.22.camel@CASE> |
Thanks Brad; On Sun, 2008-07-27 at 19:10 -0400, Brad Barnett wrote: > > If you don't care about HDTV at this point in time, just buy a PVR-250 or > PVR-500 (dual input). Even if you *do* care about HDTV, buy one of the > above, which you can use with SDTV channels anyhow. These are the most > stable (driver wise) of Hauppauge's products under Linux, as they've been > around for many a year. > I don't need the dual input. I had looked and the PVR-250, which is probably my best bet. But, I little techno-lust prompted the Hauppage WinTV-HVR-1800 question. > Hauppauge has a new device: > > http://www.hauppauge.com/site/products/data_hdpvr.html > > that will have full support for Linux, and will suffice for capturing > HDTV from any source, but if you don't like to hack with new / untested > hardware, wait a few months / a year to look at it seriously. > > By then, needed drivers will be in the kernel likely, and Myth will have > support on board... > The techno-lust spread to this when I read your suggestion and looked at the site. But on second (rational) thought, it really is more than I need. PVR-250 it is then. -- Regards Bill; Fedora 9, Gnome 2.22.3 Evo.2.22.3.1, Emacs 22.2.1 -- OCLUG general discussion list [email protected] http://oclug.on.ca/mailman/listinfo/oclug